How to Trim St. Louis Style & Full Spare Ribs YouTube

How to Trim a Rack of Spare Ribs to a St Louis Style Cut The Meatwave

Chef David Payne demonstrates how to trim spare ribs into St. Louis Style ribs.For more information visit

How to Trim Spare Ribs Step By Step Guide for St. Louis Style Smoked

Locate the sweet spot on the spare ribs, also known as the "St. Louis cut." This is the portion of the ribs that is meatier and contains less cartilage. To find it, look for the area between the rib bones where the meat is thickest. Make the First Cut. Position the ribs on the cutting board with the meat side down.

St. Louis Spare Ribs Recipe smoked low and slow

The first of the two is removing the flap of meat at the end of the rack. To do this, look at the narrower end of the rack and locate the last, shortest bone. There's usually a portion of meat attached to that bone that's loose and will end up overcooking if not trimmed off. So to remove that, make a vertical cut parallel to, and about 1/2-inch.

Trim Spare Ribs into St Louis style Pork Rib Butchery YouTube

In today's video we are going to go over how I trim my pork spare ribs St. Louis style. A few reasons you might want to trim your spare ribs into St. Louis s.

How to Trim St. Louis Style & Full Spare Ribs YouTube

Use your knife to get under the corner of the membrane, and then using a paper towel try to get some purchase on the corner. Slowly pull the membrane away from the ribs, and try not to let it tear. This can take some practice, but after a few attempts you'll be a master in no time. If the membrane does tear, don't worry.


Remove the ribs from the oven. Turn the oven on to broil. Flip the ribs over and brush the bone side lightly with about 1/4 cup of the barbecue sauce. Broil one rack at a time on the upper rack until the sauce bubbles, 2 to 3 minutes. Flip the ribs over and brush the meaty side with the remaining 3/4 cup barbecue sauce.


To start, feel for the first bone on the small end of the ribs, then make a cut just to the side of that bone to trim off the end flap of meat. Next, feel along the top of the rack for where the tops of the bones end and the cartilage takes over. Once you have a feel for where that is, cut along that line to separate the cartilage portion of.

How to Trim spare ribs into St. Louis style ribs « Meat Recipes

Add the ribs to the smoker and cook for 1 hour. Spray the ribs with 8-10 sprays of the spritzer. Repeat this process for the next 90 minutes then cook for 30 more minutes. After 3 hours total of smoking time, remove the ribs. 1Pour about a ½ cup of the mixed sauce over the ribs and rub it in on all sides.

How to Trim Spare Ribs the Right Way [4 Easy Steps]

Aids in tenderizing. Just mix the rub ingredients together in a small bowl, and it's ready to go. Apply the rub liberally to both sides of the ribs. Allow the ribs to rest with the rub for 2 hours to 24 hours. Refrigerate if needed, and cover them with plastic wrap if you do. Most rubs contain a good amount of salt.

How to Trim a Rack of Spare Ribs to a St Louis Style Cut The Meatwave

Instructions. Preheat the oven to 250°F. Make the rub by mixing the brown sugar, garlic powder, onion powder, salt, black pepper and smoked paprika in a bowl. Rinse and dry the ribs with paper towels. Remove the membrane from the underside of the ribs if it hasn't already been removed by the butcher.

How to Trim Spareribs into a St. Louis Cut for Barbecue Howcast

Trimming Spare Ribs. With a St Louis cut, a lot of the hard work will have been done for you. However, you will still need to trim the spare ribs to get the rack into as perfect a rectangle as possible.. With the ribs on a chopping board, insert a sharp knife into the top of the longest bone and make a straight long cut, parallel to the bottom of the ribs.


The process takes about 5 minutes (or less once you get the hang of it). 1. Remove the end flap. At the smaller end of your rack of ribs where the shortest bone is located, there will be a small flap of meat that is rounded at the edge. This flap of meat won't cook evenly with the rest of the rack of ribs, so it's best to just trim it off.

How to Barbecue Spare Ribs St. Louis Style YouTube

The first thing to do is remove the ribs from their packaging. Before trimming spare ribs, use a paper towel to pat dry both sides - the meat side and the bone side. Pork spare ribs pat dried, bone-side up. 2. Remove the Flap. Have the spare ribs oriented so that the bone side is up. With your knife, remove the "flap" meat; The flap meat.

How to Trim a Rack of Spare Ribs to a St Louis Style Cut The Meatwave

There are two general cuts when it comes to Pork Spare Ribs. In this video I demonstrate how to do both methods.-----.

[Homemade] St Louis cut Spare Ribs r/food

Step 3 Evenly distribute butter cubes over ribs, wrap tightly in foil, and place on prepared baking sheet. Bake until very tender, about 2 1/2 hours. Bake until very tender, about 2 1/2 hours.

How to Trim Spare Ribs into a St. Louis Cut TruBBQtv YouTube

And finally, remove the tough, rubbery membrane that covers the back of the ribs. To do this, carefully insert a butter knife between one of the bones and the membrane to detach. Using paper towels, grab the loosened membrane and peel it off from the entire slab of ribs. 5. Your St-Louis Style Ribs are now ready to be seasoned and smoked.